3M 3M-Matic 800rf, Инструкция и перечень запасных частей

Страница: 35 / 122

23
800rf-NA
2012 March
7-INSTALLATION AND SET-UP
(continued)
7.9 Completion of Taping Heads
See Manual 2 for Complete Instructions:
1. Place the Upper Taping Head in a convenient
working position
.2. Use
Figure 7-22
and tape threading label.
Position the tape supply roll so the adhesive
side of tape is facing the front of the taping head
as it is pulled from the supply roll.
3. Attach the threading needle to the end of the
roll. Guide the threading needle around the wrap
roller
(Position 1)
then back around the one-
way tension roller
(Position 2).
4. Continue pulling the threading needle down and
guide it between the two (2) rollers on the apply
arm
(Position 3).
5. Pull the threading needle down until the tape
travels between the apply plate and the ears of
the apply arm
(Position 4)
until it extends past
the applying roller. When properly threaded the
adhesive side of the tape should be facing the
knurled rollers at position 2 and also position 3.
6. Cut away any excess tape and repeat steps for
Lower Taping Head.
Important –
Do not cut against the apply roller -
roller damage could occur.
One Way
Tension
Roller
Tension
Wrap
Roller
Knurled
Roller
Wrap
Roller
Applying
Roller
Threading
Needle
#1
#2
#3
#4
Figure 7-27