10
6.3
Use the 1.5" (38 mm) rubber tape included with the gasket
to build the cable seals. Check the placement of the tape
by positioning the strength member clamp where it will be
anchored to the cable tie down bracket.
Wrap the supplied rubber tape between sealing washers
2" (51 mm) from cable sheath end.
The tape should be wrapped to 1" (25 mm) outside
diameter. Use the Tape Collar Gauge to determine tape
wrap. Tape wrap should not be smaller than the left side
of the gauge, and not larger than the right side of the
gauge.
Note:
Stretch tape slightly to ensure better fit between
washers.
Note:
If using 1" (25 mm) cables, the supplied 1.5" (38
mm) rubber tape is not required.
6.4
If using sealing plug(s), apply the supplied 1.5" (38 mm)
rubber tape to the plug(s). Wrap tape to 1" (25 mm)
outside diameter, approximately 2 1/2 wraps. Tape collar
gauge can be used to determine tape wrap.
6.5
Apply the supplied silicone grease to the inside and
outside of the port area on the gasket. Apply the grease
to the gasket area between the ports, and to the top of the
gasket along the sides of the closure.
Note:
Carefully follow health, safety and environmental
instructions as given on Material Safety Data Sheet
for the silicone grease.
