3Dlabs Wildcat III 6110, Руководство пользователя

Страница: 16 / 56

Software Configuration
3Dlabs Graphics Accelerator Card User's Guide
Connecting a VGA monitor
NOTE: You must use a DVI-to-Analog adapter to connect a VGA monitor to the Wildcat III
6210 or Wildcat III 6110. Contact Molex (1-800-78MOLEX) for a “DVI-Analog to VGA”
cable (88741-8300) or a “DVI-Analog Plug to VGA Receptacle” dongle adapter
(88741-8700).
1. Connect the monitor’s 15-pin VGA connector to the VGA end (see below) of the
DVI-to-Analog adapter.
2. Connect the DVI-I end of the adapter to the primary DVI-I port (label “1”) on the
3Dlabs Wildcat III 6210 or Wildcat III 6110 video card.
NOTE: If you are connecting both a VGA and digital flat panel monitor, you must connect
the VGA monitor to the primary DVI-I port (labeled “1”).
3. Turn on power to the workstation. If the monitor’s Power On LED does not
illuminate or the monitor does not display the startup sequence, consult Chapter 4,
“Troubleshooting.”
NOTE: If your monitor does not have a built-in video cable, use a shielded video cable
with either a DVI-I receptacle or a 15-pin VGA video connector (with adapter) at one
end for the video output port on the card, and the appropriate connectors at the
other end for the video input port on the monitor. See the documentation delivered
with your monitor for more information.
If you ordered the Wildcat III 6210 or Wildcat III 6110 video card with a system, it
was installed and configured prior to shipment. See Chapter 3,
“Using the Video
Card," for instructions on adjusting the resolution, color depth, and refresh rate.