3D Systems ProJet 5000, Руководство пользователя

Страница: 6 / 14

05.2 Access Area Surrounding Printers
At least 36" (908mm) of unobstructed floor space is recommended around each accomodate, to allow unobstructed service access to the
drawers, hood and doors.
Store crate where it will be easy access to wheel locks or have a jack lift available for the 3D Systems Field Engineers when installation
occurs.
05.3 Unit Portability
NEVER unpack, assemble, or connect any component of the shipment without the aid of a qualified, 3D Systems Field
Service Engineer or authorized reseller. 3D Systems accepts no responsibility for damaged, defective, or incomplete
systems uncrated by anyone other than 3D Systems Field Service Engineer or authorized reseller.
The casters provided have a small diameter and are not intended for use on rough or uneven surfaces including deep
carpet.
To avoid the risk of tipping the printer when moving between locations, only push from the side of the printer.
The printer is intended to be lifted from its crate base using a fork lift device and place on casters to roll to its final
destination. Leveled fork lift pads have been placed beneath the machine to accommodate this need. The front and rear
guard panels must be removed prior to lifting.
The ProJet™ Printing System is equipped with four caster-type rollers, as well as four integral threaded feet. Leveling can be adjusted using the
threaded leveling feet, and tighten in place to secure the printer.
Once the printer is installed, it cannot be moved without the aid of a qualified, 3D Systems Field Service Engineer or
authorized reseller. 3D Systems accepts no responsibility for damage to the printer by anyone other than 3D Systems
Field Service Engineer or authorized reseller.