3D Systems, Inc.
28
INSTALL MATERIAL CARTRIDGES (CONT’D)
1 . Unpack cartridges and the MSDS/SDS Sheet from cartons . Save sleeves and material carton to store partially used material
cartridges .
2 . Open material delivery module and install two parts cartridge into the right side of module . Pull levers up and place cartridges
down into holder until they are fully seated .
3 . Insert the support material cartridges; ensure they are fully seated into the two left side holders .
NOTE: If cartridges are not fully seated in holders, the drawer will not close.
CLEANING MDM HOLDERS
When changing material bottles during printing, molten material may be present in the MDM holder after the bottle is removed . If a
large pool of material is present (latch is submerged and walls of MDM are reached), do not place a clean material bottle into holder .
The holder will require cleaning before inserting a new bottle .
Caution: The MDM holder and molten material will be hot; avoid touching the sides of the holder during the cleaning
process. Wear heat resistant gloves and goggles.
To Clean:
•
Insert a lint free cloth to absorb the material in the MDM holder .
•
Using a long tool, such as tongs; remove the saturated cloth from the holder and place in a waste bag . Continue to clean the
holder until all material is removed .
•
After the holder is clean, ensure there is no debris or lint left inside of holder .
•
Dispose of waste material and according to your local codes .
