3D AEROWORKS X-88 Fun-Jet, Руководство по сборке и инструкция пользователя

Страница: 18 / 26

- Insert the torque link and rod through the aileron end of the torque link tube and
secure it to the servo.
- Install the servo into the wing, the servo gear needs to be on the same side as the
tube for the torque link (see below). Note- The mount plates in the wing for the servo
consist of 4 layers and are quite thick. Pre-drilling with a 1.5mm drill bit is advised
before mounting with m2 screws.
- Assemble the connector and the torque link using a small screw. NOTE - The torque
link needs to be fitted to the connector so that the screw holds the push rod in the
torque link. See image. (fitting it the other way will allow the rod to fall out of the torque
link)
RDS INSTALLED