3Com VCX V7000, Руководство по установке и обслуживанию

Страница: 136 / 144

136 A
PPENDIX
B: R
EPLACING A
F
AILED
D
ISK ON A
VCX S
ERVER
2 Enter these commands:
cd /etc/rc.d/rc3.d
./S99vcx start
NOTE: This marks the end of the outage.
Replacing a UMS
Server Disk in a
Four-Server
Configuration
Use this procedure to replace a disk on either UMS server in a four-server
configuration.
To replace a disk on either Call Processor server in a four-server
configuration, see
“Replacing a Call Processor Server Disk in a Four-Server
Configuration” , earlier in this appendix.
To replace a disk on either server in a two-server configuration, see
“Replacing a Disk in a Two-Server Configuration” , earlier in this
appendix.
A service person arrives with a laptop that is used to connect to the serial
port on the down server. The laptop functions as the console terminal
because VCX servers have no keyboard or monitor.
The service person isolates the down server from the network to avoid
the possibility of telephones trying to access it before it is ready.
The service person replaces the disk drive and reboots the system.
1 The following prompt appears:
Configure Networking now?
2 Enter yes and then answer the questions to configure the network
parameters for the down server. For detailed instructions, see “Sample
Network and Initial Configuration Script (Primary UMS Server)” or
“Sample Network and Initial Configuration Script (Secondary UMS
Server)”
in Chapter 3 .
3 Answer the questions that are posed by the UMS installation scripts to
configure the various components. For detailed instructions, see
“Sample
UMS Installation Script (Primary UMS Server)” or “Sample UMS
Installation Script (Secondary UMS Server)” in Chapter 3 .
4 After you have answered all of the questions and have rebooted the
server, enter this command, for each of four IP addresses associated with
the VCX servers: