3Com Switch 4210 9-Port, Руководство по настройке

Страница: 55 / 567

Logging in Using a Modem 53
Switch Configuration
n
After logging into a switch through its Console port by using a modem, you will
enter the AUX user interface. The corresponding configuration on the switch is the
same as those when logging into the switch locally through its Console port
except that:
■
When you log in through the Console port using a modem, the baud rate of
the Console port is usually set to a value lower than the transmission speed of
the modem. Otherwise, packets may get lost.
■
Other settings of the Console port, such as the check mode, the stop bits, and
the data bits, remain the default.
The configuration on the switch depends on the authentication mode the user is
in. Refer to Table 13 for the information about authentication mode configuration.
Configuration on switch when the authentication mode is none
Refer to “Configuring Console Port Login with no Authentication” on page 27.
Configuration on switch when the authentication mode is password
Refer to “Configuring Console Port Login to Require a Password” on page 31.
Configuration on switch when the authentication mode is scheme
Refer to “Console Port Login Configuration with Authentication Mode Being
Scheme” on page 34.
Establishin a Modem
Connection
1 Before using Modem to log in the switch, perform corresponding configuration
for different authentication modes on the switch. Refer to “Configuring Console
Port Login with no Authentication”, “Configuring Console Port Login to Require a
Password”, and “Console Port Login Configuration with Authentication Mode
Being Scheme” for more.
2 Perform the following configuration to the modem directly connected to the
switch. Refer to “Modem Configuration” for related configuration.
3 Connect your PC, the modems, and the switch, as shown in Figure 17. Make sure
the modems are properly connected to telephone lines.