54
C
HAPTER
5: T
ROUBLESHOOTING
Forgotten Password
and Reset to
Factory Defaults
If you can browse to the Access Point configuration screen but cannot log
on because you do not know or have forgotten the password, follow the
steps below to reset the Access Point to it’s factory default configuration.
CAUTION:
All your configuration changes will be lost, and you will need
to run the configuration wizard again before you can re-establish your
wireless network. All other computer users will lose their network
connections whilst this process is taking place, so choose a time when
this would be convenient.
1
Remove power from the Access Point.
2
Hold down the
Reset
button on the rear of the unit and re-apply power
to the Access Point. The Alert LED will flash as the Access Point starts up,
and after approximately 30 seconds will start to flash more slowly
(typically 2 seconds on, 2 seconds off). Once the Alert LED has started to
flash slowly. Keep
Reset
button held down and remove power from the
Access Point.
3
Release the
Reset
button.
4
Re-apply power to the Access Point, and when the start-up sequence has
completed, browse to the IP address of the Access Point and run the
configuration wizard. You may need to restart your computer before you
attempt this.
5
When the configuration wizard has completed, you may reconnect your
network as it was before.
Wireless
Networking
■
Ensure that you have a Wi-fi certified 802.11b wireless adapter for
each wireless computer, and that it is correctly installed and
configured. Verify that each Wireless computer has either Windows
95 or higher or MAC OS 8.5 or higher.
■
Verify that your wireless computers are configured to work in
Infrastructure mode and not Ad Hoc mode. The Access Point is
designed to operate in Infrastructure mode. Ad Hoc mode is not
supported by the Access Point.
■
Check the status of the Access Point Wireless LED, it should be lit if
wireless is enabled and will flash when there is wireless activity. If not
lit go to
“Wireless Settings”
on
page 37
and enable wireless
networking.
■
Ensure that the TCP/IP settings for all devices are correct.
Содержание OfficeConnect 3CRWE41196
