8
Restarting the OfficeConnect Remote 612 ADSL Router:
To restart the OfficeConnect Remote 612, use the Restart/Restore
Section in the Advanced Menu in the User Manager.
Restoring Factory Default Settings:
To reset the Router to the factory default settings, disconnect the
Ethernet cable and then press and hold the Reset button, shown
in Figure 1. While holding in the Reset button, unplug the power
from the back of the Router and then plug it back in. Hold the
Reset button in for approximately 15 seconds (the Alert light on
the front of the Router should be green). Alternately, you can use
the Restart/Restore Section in the Advanced Menu in the User
Manager.
Connecting an additional hub:
After you have finished the configuration of your OfficeConnect
Remote 612, you can connect an Ethernet hub to add up to 40
users, which is the maximum supported by the OfficeConnect
Remote 612.
An example of an eight-user connection is shown below (Fig 13),
using a 3Com OfficeConnect Ethernet Hub 8.
1. Verify network configuration.
Check with your network administrator that the built-in DHCP
server will not cause conflicts on the network.
2. Connect the LAN cable.
Connect one end of the LAN cable to
a port of the ethernet hub and the
other end to the Ethernet port on the
rear panel of the Router.
3. Uplink port configuration
Set the PC/HUB switch to “Out” when
you are connecting a hub. Check the
documentation of the hub you are
using for the configuration of the
uplink port on the hub, if the hub has
one.
Connecting
multiple
users
Restart and
Restore
OfficeConnect Remote 612
ADSL Router
OfficeConnect
Ethernet Hub 8
Ethernet cable
10-18 V
DC
0• 8A M
AX
MDI/MDIX
8 7 6 5 4 3 2 1
Figure 13
