3Com Fast EtherLink 3C515-TX, Руководство пользователя, Страница: 20 / 80

2-6 C
HAPTER
2: I
NSTALLING THE
NIC
Figure 2-5 Connecting the Network Cable to the RJ-45 Connector
2 Connect the other end of the network cable to a
10BASE-T or a 100BASE-TX network port.
3 Check the LEDs, shown in Figure 2-5.
After installation, and before you install the network
driver, the LEDs indicate the following:
■
10 LNK LED lights green to show 10 Mbps
link integrity.
■
100 LNK lights green to show 100 Mbps link integrity.
■
ACT LED is OFF until the network driver is installed
and then lights yellow to indicate port traffic for
either speed.
For information on what the LEDs indicate after the
network driver is loaded, see Table 5-1.
The next step is to load the network driver. See Chapter 3
for Novell NetWare driver information and Chapter 4 for
NDIS network driver information.
RJ-45 port
RJ-45
connector
100 LNK LED
10 LNK LED
ACT LED
100
TX
TX
L
N
K
10
ACT