3Com 4400, Руководство по началу работы

Страница: 39 / 86

Manually Configuring IP Information 39
Manually
Configuring IP
Information
You can manually configure the Switch IP information in the following
ways:
■
Connecting to a front panel port — Connect a workstation using an
Ethernet cable to a front panel port of the Switch. You can then
manually enter IP information using the web interface or the
command line interface (CLI).
■
Connecting to the console port — Connect a workstation using a
console cable to the console port of the Switch. You can then
manually enter IP information using the command line interface (CLI).
Connecting to a Front
Panel Port
To set up your Switch manually you can make a connection to a front
panel port. You must do this whilst the Switch is offline, that is, before
you connect the Switch to a network.
The procedure described in this section assumes the unit has been
powered up in standalone mode and has the default IP address of
169.254.100.100.
Pre-requisites
■
A workstation running Windows 95/98/2000, Windows NT or
Windows XP.
■
A Network Interface Card (NIC).
■
A Category 5 twisted pair Ethernet cable with RJ-45 connectors.
■
A suitable Web browser — refer to “Choosing a Browser” on page 52 .
■
You need to have the following so that you can manually set up the
Switch with IP information:
■
IP address
■
subnet mask
■
default gateway
DUA1720-3AAA05.book Page 39 Friday, March 7, 2003 11:53 AM