3Com 3C8S5007 - SuperStack II PathBuilder S500..., Руководство пользователя

Страница: 112 / 190

112 A
PPENDIX
E: T
ROUBLESHOOTING
Boot
Syntax
BT [<filename> [<boot_drive:path>]]
Description
The BT command allows you to reboot or to override the default boot
path configured in the firmware by the monitor or by the SysconF
command in the software. If you enter a new boot drive or path, the
firmware parameter is updated to reflect the new path.
If you do not enter a filename or a configuration file directory, the system
attempts to boot using the boot.ppc file referenced by the boot directory
in the primary boot source. If there is an error, a message is sent to the
console and you are returned to the monitor utility.
Errors include:
■
The file does not exist.
■
The file has the wrong format.
■
The file has a bad checksum.
Configure Flash Load
Syntax
CL
Description
The CL command allows you to configure the following settings to
identify a TFTP server for downloading a boot image:
1. Client
2. Server
3. Gateway
4. Subnet Mask
5. Boot Filename
6. Port Selection
7. Baud Rate
8. Duplex Mode
Clear PID
Syntax
CP
Description The CP command erases the Product ID (PID) except for the MAC
address.
CAUTION: The CP command erases the PID except for the MAC
address. You should only do this if advised by 3Com technical support.