3Com 3C8S5007 - SuperStack II PathBuilder S500..., Руководство пользователя

Страница: 149 / 190

Example Configuration Templates 149
########################################################################
########################################################################
# ULTRAWAN CONNECTOR CONFIGURATION FILE
# T1 PRI TEMPLATE
# HOW TO CONFIGURE A SINGLE CONNECTOR
# This example shows how to configure connector 4A. To configure
# connectors other than 4A, substitute the connector name, accordingly
# For example, to configure connector 4B, replace 4A with 4B
# in all of the commands shown below
# Connector-level path parameter configuration
# The following parameter settings are only typical example settings.
# Your network-specific settings need to be assigned by consulting the
# connector-level path parameter documentation in the document
# "Using the PathBuilder Switch"
SETDefault !4A -PAth FrameMode = T1_ESF
SETDefault !4A -PAth CONNector = T1_Pri
SETDefault !4A -PAth SwitchType = ATT5ESS
SETDefault !4A -PAth LineCoding = B8ZS
SETDefault !4A -PAth LineDistance = LH1
SETDefault !4A -PAth CLock = External
# Path-level path parameter configuration
# The following parameters may need to be changed from their default
# settings, based on your specific environment topology:
#
# LocalDialNo: If you want outbound calls to provide a calling
# phone number, you will need to set this parameter
# for each path that will support outbound calls.
# There is no default setting for this parameter.
# Rate Adaption: If you want outbound calls using a given path to
# attempt connection only at one rate (56K or 64K),
# but not both, then this parameter will need to be
# changed from the default setting of AUTO (which,
# if necessary, attempts both) to Rate56K, or Rate64K.
#
# Some examples on changing these parameter settings are:
#
# SETDefault !4A.1 -PAth LocalDialNo = "4085551212"
# SETDefault !4A.5 -PAth LocalDialNo = "4085551212"
# SETDefault !4A.23 -PAth LocalDialNo = "4085555555"
#
# SETDefault !4A.1 -PAth RateAdaption = "Rate56"
# SETDefault !4A.5 -PAth RateAdaption = "Rate56"
# SETDefault !4A.23 -PAth RateAdaption = "Rate56"
# ........