Initial Configuration from UNIX-based Platforms
2-7
You also need to specify if this community can only read
information, or read and write information.
>>> Can this community change management information [yes]?
This completes the section on SNMP management configuration.
>>> Do you want to allow command line management via TELNET
[yes]?
For TELNET management of the system you need to create a user
name and password to control access.
>>> What user name will be allowed to manage this system
[administrator]?
>>> What password will be used for this user []?
password
>>> Do you want to set up the syslog daemon [no]? n
>>> Would you like to set up radius accounting [no]? n
>>> Would you like to set up radius authentication [no]? n
Quick Setup IP information
--------------------------
The RAS1500 uses a network name to identify the network for
future management commands.
>>> Enter the network name of your IP network [ip]:
>>> Enter the IP address for the RAS1500 []: 192.168.1.1
The IP mask can be specified as a class ("A", "B", or "C"),
the number of one bits in the mask, or as an address in the
format
255.x.x.x
>>> What should the mask be set to [C]?
You need to specify the framing for the IP network. It should
be either "ethernet_ii" or "snap".
>>> What is the framing for the IP network [ethernet_ii]?
>>>Do you want to set up a default gateway [yes]?
The default gateway gives the address of a router that the
RAS1500 will forward packets to when it has no other route to
their destination. It cannot be the same address as the IP
address for the RAS1500 nor can it be a broadcast address for
its IP address class.
