Installation Using Point Enabler
15
No Networking Installed
This procedure assumes that you have not already installed Windows NT
networking on your notebook computer. If networking is installed, see
“Networking Already Installed” on page 16.
1
In the Control Panel, double-click
Network
.
2
When the system prompts: ”Windows NT Networking is not installed. Do you
want to install it now?”, click
Yes
. This opens the Network Setup Wizard.
If the Network Setup Wizard does not appear, refer to “Networking Already
Installed” on page 16.
3
Check
Wired to the network
and click
Next
.
4
When the system prompts to have setup start searching for a network adapter,
click
Select
from List.
5
Click
Have Disk
. Insert the LAN PC Card
Installation CD
(disk) in the CD-ROM drive
and click
OK
. Use the path
d:\install\disks\574BT
, where d: is your CD-ROM drive.
6
When the Select OEM Option window opens, select
FE574 - 3Com 10/100 LAN PC
Card-Fast Ethernet
and click
OK
.
7
The
Network Adapters
list shows a check mark next to the 3Com LAN card. Click
Next
to continue.
8
In the Network Protocols list, place a check mark next to each network protocol
required for your site and click
Next
.
9
In the Network Services window, place a check mark in the box next to each
desired service. Unless you are following specific guidelines from your MIS
department, select the default settings.
10
Click
Nex
t to install the selected components.
11
When prompted, enter the path to the Windows NT installation files (for example,
D:\i386 on the NT CD) and click
Continue
. The window will appear again with the
fields blank.
12
Remove the NT CD and insert the LAN PC Card
Installation CD
in the CD-ROM
drive and click
OK
.
13
Specify the path
d:\install\disks\574BT
, where d: is your CD-ROM drive, and click
Continue
.
14
In the 3Com LAN card dialog box, accept the default settings and click
Continue
.
Depending on your computer’s current settings, a TCP/IP setup windows may
appear. Select the options that are required for your site and continue.
15
When the window for enabling or disabling protocols opens, click
Next
.
16
When NT is ready to start the network, click
Next
to copy the network files.
17
Provide your computer name and workgroup or domain name when prompted.
18
When the system displays “Networking has been installed on your computer,”
click
Finish
.
19
When prompted to reboot the computer, remove the LAN card
Installation CD
from the CD-ROM drive and click Yes.
