360 Systems MAXX, Руководство по эксплуатации

Страница: 37 / 137

Basic Operations 35
3. Select the first file in a sequential list of files to be deleted. Press and hold the Shift
key, then click on the last file in the list to be deleted. The selected list will appear
highlighted and all may be deleted with a single click of the Delete button.
4. While holding the Control (Ctrl) key down, click to select any number of files (in
any order) to be tagged for deletion, then click Delete.
Note: The Ctrl key allows toggling selections, and may be used to de-select files that
were accidentally highlighted. This is also useful in combination with the Shift key.
A large block may be highlighted using the Shift key, then use the Ctrl key and
mouse to de-select individual files from within the highlighted list. The Ctrl key
may also be used to add additional files to the block created with the Shift selection
method.
Exit
Exit will close the current Channel window. A prompt will appear to save a recording
if the file or its edits are new. Exit is grayed-out when Record or Edit operations are in
progress.
The Status Bar
A status bar appears at the bottom of the window that provides system information to the user
including
GENLOCK
,
INPUT VIDEO DETECTED
, and
TIME REMAINING
—
PERCENT FULL
. Messages such
as
CONNECTED TO HOST
or
CONNECTION TO HOST REFUSED
are also displayed as diagnostics.
Error and status messages from the RAID system can also be displayed here.
Transport Controls
The clip window button functions are common to both recording and playback of a clip. This
section introduces the buttons by function. See
Recording on page 42, and Playing a Clip on
page 45 for relevant procedures.
Remote
Select
Remote
to control the channel using controllers or automation systems connected to
the serial control ports. The GUI can take control of a channel at any time by un-checking
the
Remote
check box. If a remote controller is operating on the channel, deselecting
Remote
will immediately cause the GUI to assume control of the channel; remote
commands will be ignored. Closing the channel window saves the Local/Remote setting in
the last-selected state.
NOTE 1: When the Channel is under Remote control it will continue to display current
activity.
NOTE 2: Some remote controllers may need to be reinitialized to restore proper operation
after local control is selected and then released.