25
Chapter 5 Methods of Wiring Connections for 16 Channels Signal Processor
CI-16-ASP-485 for
Power and Video
Transmission (continue)
(6) A short length of bell cable is connected between the “DC Power to Camera”
Push-Fit Terminals and the Camera, while a short length of suitable cable is
connected between the BNC Plug of the Push-Fit Mixer and the Camera as shown
at A of Fig. 5.1.1 and in Fig. 5.1.2.
Wiring Connection for other channels:
4. The wiring connections for channels 5 to 8, 9 to 12, and 13 to 16 are connected similarly
as described in paragraphs 1 to 3 above.
Description of the Power Supply and Transmission of Video Signals:
5. With the wiring connection described above, the Power Supply is provided from the
Built-in Power pack in the Signal Processor through the Cat.5 wires via the Distribution
Board with RJ45 Sockets and Cat.5 wires to the CC-1RJ Cable Converter and Mixers,
and then to the Cameras. The Video Signals are transmitted from the Cameras via the
Mixers and CC-1RJ Cable Converter through the same pair of Cat.5 wires to the Signal
Processor, and then through the corresponding Video Output - BNC Plugs
○
6
in Fig.
4-1.3 (on Page 12) for further connection to the DVR/Monitor as shown in Fig. 5.1.1.
