1
Installing and Configuring the Gateway
Windows 98/SE/2K/ME/XP and Macintosh OS 10.2
Congratulations on the purchase of your 2Wire gateway. To install your gateway and configure your home
network, follow these steps.
Note:
Features for different models may vary. Product details will be specified for each particular
model.
Note:
TO MAC OS 9.X AND OTHER OPERATING SYSTEM USERS:
Users running Mac OS 9.X
and operating systems other than those stated above must perform a manual configuration of the
gateway. Refer to Appendix C for step-by-step instructions.
Insert the 2Wire Setup Wizard CD and follow the on-screen instructions
Do
NOT
install any equipment until instructed by the CD during your installation.
Enter key code
If you were provided with a 20-digit key code by your service provider, enter it when prompted. If you were
not provided with a key code, refer to “Appendix E: Back-Up Key Codes” on page 16.
Add computers to your network
Insert the 2Wire Setup Wizard CD into the CD-ROM drive of each computer that you wish to connect to your
network and follow the on-screen instructions.
