2N 9135110E, Руководство по установке

Страница: 55 / 77

Installation manual 2N® Analog Vario
55 / 77
The switch activation time can be programmed once the switch is enabled this will also
automatically terminate the call in the next 30
seconds.
Switch 2 activation (light, e.g.)
The second switch (if an additional switch is installed) can be controlled in the same way.
Switch 2 synchronisation
Switch 2 can also be used to delay the opening of another door. Once the switch 2 delay timeout
is programmed, the second switch is synchronised automatically with the first one, the delay
being
1– 25 seconds.
Switch activation signalling (for both switches)
After the correct password is entered, the switch is activated and you can hear the confirmation
signal on your telephone. You can now speak (e.g. say: "The door is open") or listen (to the door-
opening sound, etc.) until the switch is deactivated. Upon deactivation, you can hear the storing
signal (see the Signals Overview).
Call extension
2N
®
Analog Vario beeps 10 seconds before the call end to extend the call by 30 seconds press
on your telephone (DTMF). You can use this function repeatedly. The visitor, however, cannot
use this function!
Programming
The access to this mode is password-protected. For details refer to the Programming section.
The voice menu considerably helps with
programming 2N
®
Analog Vario . Having entered the
programming mode, you can also alter any parameter and memory settings.
•
•
Note
If the Automatic Multiple Number Dialling with Confirmation or the Silent
Automatic Multiple Number Dialling with Confirmation mode is selected and the
password starts with digits 1 to 5, an asterisk must always be used.
You Must enter every digit in the password within five seconds (or as pre-
programmed) to avoid 2N
®
Analog Vario from hanging up.
