33
Copyright © 2021 Nortek Security & Control LLC
2 .
Review the
Alarms
list . Then tap
CLEAR
ALARM HISTORY
.
Alarms Screen
Emergency Features
24-Hour Alarm Buttons
Three 24-hour alarm buttons can be shown or hidden by
the installer on the Control Panel’s touchscreen:
Panic
,
Fire
, and
Emergency
.
You can open the following screen by pressing the
button on the Control Panel:
24-Hour Alarm Buttons
Panic Button
When activated, the system immediately goes into the alarm state. Depending on how the system is configured, the
Control Panel emits a loud, patterned warning siren or sets off a silent panic alarm with no siren . The system also
transmits a police report to the Central Station .
NOTES:
1
Consult your installer to determine if the
Police Emergency Key
is configured to sound an audible alarm or a
silent panic alarm .
2
Consult your installer to determine if the
2-Way Voice
feature is enabled on the system . If enabled, setting off
the Panic alarm gives operators at the Central Station the ability use the Control Panel’s built-in speaker and
microphone to converse with people on the premises .
3
Consult your installer to determine if the
Silent Panic/Burglary Listen Only
feature is enabled on the system .
If enabled, setting off the Panic alarm gives operators at the Central Station the ability to use the Control
Panel’s built-in microphone to listen . If the panic alarm is sent, the operator can only listen . For your
protection, the operator will not be heard at the panel .
Fire Button
When activated, the system immediately goes into the alarm state . The Control Panel emits a loud, patterned warning
siren that is in compliance with
ANSI S3.41 Temporal-3 Fire Alarm Signal
and continues to sound until the system is
, pg 26) or the Fire Bell Cutoff Time expires . The system also transmits a Fire
Report to the Central Station .
NOTES:
1
Consult your installer to determine how the Fire Bell Cutoff Time is configured on your system. The time
can be configured to last
4 minutes
,
8 minutes
,
12 minutes
,
16 minutes
, or
Unlimited
(no cutoff) . The default
setting is four (4) minutes .
2
If Smart Areas is enabled the Fire Button will create a global alarm in all Smart Areas . The alarm must be
acknowledged/cleared in each Smart Area .