247securityinc.com
1.866.693.7492
247securityinc.com | 1.866.693.7492 | 1455 Alderman Drive, Alpharetta GA 30005, USA
Pg.21 of 47
CONFIGURATION MENUS
ENABLE CAMERA
Click the check box to enable or disable the camera input.
CAMERA NAME
Set each camera to have a different name, usually based on where it is located in the vehicle, up
to 16 characters.
CAMERA TYPE
Select the correct camera type: analog or IP. This is normally an installer-only setting, so if unsure,
leave as default or set to Analog. Generally, cameras 1-8 are analog and 9-16 are IP.
CAMERA ROLE & ENABLE STOP ARM CAMERA
Leave the setting as Normal, unless the camera is a stop-arm camera, and is to be used for
automatic SAV detection. Check the box to enable. Consult with the installer and 247Security
regarding automatic SAV detection.
CAMERA IP ADDRESS
If Camera Type above is set to “Analog”, this field will be blank. If “IP” is selected, enter an IP
address. This setting should be set by the installer. A best practice is to use 192.168.1.1xx with
consecutive numbering.
RECORDING MODE
Three modes: CONTINUE - The camera is recorded until the DVR is powered down or the storage
media is removed from DVR. This is the typical and recommended mode for video recording.
TRIGGER BY SENSOR
- In this mode, the camera is recorded if it detects an event trigger on one of
the programmable sensors. If this mode is selected, the required sensors must be enabled.
192.168.1.149
