The following settings are for the CASIO EX-ZR65 camera,
and refer to the camera manual for setup.
(1) Align the 3 contact pins on the back of objective lens to the 3 holes
on the front side of module. (fig. )
(2) Rotate the lens spiral tooth clockwise until it is tight. But do not over-tighten!
(3) Open the battery cover on the bottom of module (press and slide the battery
cover in the direction indicated by the arrow), and fill in fully-charged
NB-4L Li-ion battery. (fig. )
(4) Turn on module power. It will light up if the assembly operation is correct.
SET
MODE
Magnifying Glass
4
BEST SHOT
BS
★
Notice and Preparation for Photography
★
(1)Press
[MODE]
, use ▲/▼/◄/► to select the top-right corner of
[BS]
(BEST SHOT), and press
[SET]
, this will display a menu of
BEST SHOT scenes; then once again select the top-right corner
of
[Magnifying Glass]
.
(2)Shooting with this Scene, the settings will automatically be
selected as follows:
Flash setting → Flash Off / Optical zoom → Full wide angle
Focusing → Marco focus / AF metering area → Spot
Product Assembly
Step1
Mount objective lens to module
*Please ensure that you read and understand the safety precautions. Please refer to product instruction.
If failure to observe instructions on the use cause the damage to product is excluded from the warranty.
Red Dot
Turn 30 degrees clockwise
Digital Still Camera
Microscope module
Objective Lens
On(Red dot) / Off switch
LED
Illumination Control
(White LED)
★
The diagrams in this manual are based on model C101;
the appearance is slightly different from model A500,
but both models take the same assembly operation and using method.
Front of Objective Lens
Magnifying Glass
Step2
Confirm the completion of the camera settings
Make sure to follow the
"Notice and preparation for Photography"
to complete the camera mode setting.
Before making the combination of module and camera,
the camera must be in the mode of
[Magnifying Glass]
(correspond
this mode, the length for camera lens as it extends will be locked out).
Note:
Follow the direction
to fill in battery
(1) Align the mount positioning on the mount ring (at the rear of module)
with the red dot above the camera mount. (fig. )
(2) Attach module to camera and turn 30 degrees clockwise
until both bodies are firmly combined. (fig. )
(3) Turn on the camera and module power. The image will appear on LCD screen if the handling
is correct. If the lens barrel can not extend properly, or error code shows on camera monitor,
please refer to the troubleshooting section.
Step3
Mount module to camera
MODE
SET
Control Panel
Camera Back
Back of Objective Lens
If unable to solve, please immediately contact your distributor for assistance.
DO NOT try to modify X-Loupe
®
product by yourself in any way.
Front of Module
Back of Module
Pogo pin
Pogo pin
Mount adapter
X-Loupe
®
Portable Microscope Camera System User Guide
Primary kit C101 / A500
Each model contains two interchangeable lens
with the magnification distinguished by color.
C101 / 80X → Green; 160X → Light Blue
A500 /
60X →
Red;
150X → Blue
