Figure 1
Figure 2
Figure 3
272410 (Single Ratchet)
272410 (Double Ratchet)
272412 (Vending)
Description
The Wesco Aluminum Vending Machine Truck is specifically
designed for transporting loads of up to 550 lbs. It features a
lightweight aluminum frame with auto rewind ratchet, 6”
moldon rubber wheels and a 24” wide by 5” deep nose plate.
This product is distributed by:
Wesco Industrial Products, LLC
1250 Welsh Road
North Wales, PA 19454
Tel: 215-699-7031 Fax: 215-699-3836
Contact the factory for parts information and ordering.
Visit us on the web at www.wescomfg.com
Unpacking
When unpacking the Wesco Product, check carefully for
shipping damage and missing parts. If damage has occurred
or any parts are missing, file a claim with the delivering carrier
within 24 hours and notify the dealer from whom the unit was
purchased.
Warranty Repairs
If the unit does not work properly, contact your dealer or the
factory (215-699-7031) for units less than 90 days old.
Non-Warranty Service
If units are older than 90 days, repairs can be made easily on
site with factory supplied parts.
NOTE:
Do not send units to the factory for service without
first obtaining a “Return Merchandise Authorization” (RMA)
number from the customer service department. We will not
be responsible for merchandise returned without proper
authorization.
Economical Aluminum Appliance/Vending Machine Trucks
(P/N 272410, 272411, & 272412)
Operating Instructions and Parts Manual
ATTENTION: TO INSURE SAFE AND EASY USE OF YOUR WESCO APPLIANCE/
VENDING TRUCK, READ THESE INSTRUCTIONS BEFORE USING.
General Safety Information
The Wesco Aluminum Vending Machine Trucks are
designed for specific functions. To insure proper use, the
following instructions must be adhered to:
(1) DO NOT overload the Truck beyond the rated capacity
of the unit, Maximum capacity: 550 lbs
(2) Check truck & all hardware for wear and tightness
before use.
(3) DO NOT use if nylon belt is worn or cut. Immediately
remove unit from service and repair before use.
(4) DO NOT allow belt to twist when securing load.
(5) Firmly tighten belt around load before moving.
(6) Use extreme caution when moving on uneven floors.
(7) When using caster kickout, it must be in the fully
extended position with the support bar in the lowest
position before putting any weight on the casters.
Specifications
Part
#
272410 272411 272412
Model Number
AAP-61 AAP-612 AVT-61
Capacity (lbs.)
550 550 550
Overall Width (in.)
24 24 24”
Overall Height (in.)
61 61 61
Overall Depth (in.)
12 12 12
Wheel (in.)
6 x 2
6 x 2
6 x 2
Caster (in.)
N/A
N/A
2 x 1
Weight (lbs.)
40 43 50
