1
warema_890416_alhb_en_v2•2022-10-01
We reserve the right to make technical modifications
WARNING
It is important to comply with the following
points of instruction in the interest of per-
sonal safety.
Children may not play with the operating elements of
the control unit or the remote control. Store the remote
controls out of reach of children.
Make sure that no persons or objects are in the range
of movement of the driven parts (blinds, external vene-
tian blinds, etc.).
Disconnect the device from the supply voltage if clean-
ing or other maintenance work must be performed.
Information on the electrical installation
An on-site overload current disconnecting and isolating
switch to switch off the entire system must be provided.
Installation
The motor control unit is, depending on the selected meth-
od of installation, designed for surface mounting (AP) or for
installation in a distributor (REG).
There are two ID labels (Fig. 2) inside the device. If you are
setting up a complex unit, pull off one of the labels and af-
fix it to your wiring diagram. This measure ensures that the
device can be identified without any mistake in the event of
a later integration.
6
1
2
3
7
8
4
5
Fig. 2
LONMPM 8DI/8DO Inside view with barcode labels
1 4-fold encoding switch
2 8-fold encoding switch
3 Power LED
4 Service push button
5 Service LED
6 Status LED
7 LEDs: channel 1...8 + manual
8 ID label
General information
Fig. 1
LONMPM 8DI/8DO
The LONMPM 8DI/8DO actuator is a multifunctional mod-
ule for various control tasks. It can read in 8 floating switch-
es, push buttons or other contacts. Eight floating make
contacts are available at the control outputs. Depending on
the software in use, this module can be used for control-
ling lighting systems, monitoring window contacts and oth-
er control tasks.
Intended use
The LONMPM 8DI/8DO actuator was developed for the con-
trol of lighting, heating, cooling and ventilation units. The ap-
proval of the manufacturer must be obtained for uses out-
side of the purposes listed in these instructions.
Safety instructions
WARNING
The electrical installation (assembly)/dis-
mantling must be performed by a certified
electrician in accordance with the electri-
cal installation regulations published by
the Association of German Electrical En-
gineers (VDE 0100) or the standards and
regulations of the country in which the
device is being installed. The specialist
must observe the installation instructions
included with the electrical device.
WARNING
If hazard-free operation cannot be as-
sumed, the device may not be started or
must be deactivated. This assumption is
justified
If the housing or the supply lines show signs
of damage,
The device is no longer working.
Valid as of
1 October 2022
Keep for future use.
LONMPM 8DI/8DO
Operating and installation instructions
