Upright LX Bi-Energy, Operator'S Manual

Page: 1 / 12

1
LX Electric & Bi-Energy
Operator Manual
LX Electric & Bi-Energy
SERIAL NO. 3300 TO CURRENT
Safety
Rules
and
Operating
Instructions
Safety
Rules
and
Operating
Instructions
WARNING
All personnel shall carefully read, understand and follow all safety rules, operating
instructions and the Scaffold Industry Association’s MANUAL OF
RESPONSIBILITIES (ANSI A92.6) before operating or performing maintenance on
any UpRight aerial work platform.
SAFETY RULES
NEVER operate the machine within
ten feet of power lines. THIS
MACHINE IS NOT INSULATED .
NEVER elevate or drive elevated on
uneven slopes or soft ground or el-
evate the platform unless the plat-
form is level.
NEVER sit, stand or climb on
guardrail or midrail.
California Proposition 65 Warning
Gasoline and diesel engine exhaust and some of their constituents are known to the State of Califor-
nia to cause cancer, birth defects, and other reproductive harm.
NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs,
bumps and debris.
NEVER operate the machine if all guardrails are not properly in place and secured with all fasteners properly
torqued.
SECURE and lock gate after mounting platform.
KEEP all body parts clear of outriggers when extending or retracting (outrigger equipped machines only).
NEVER use ladders or scaffolding on the platform.
NEVER attach overhanging loads or increase platform size.
MAINTAIN tire pressure at 50 psi. Check daily.
LOOK up, down and around for overhead obstructions and electrical conductors.
DISTRIBUTE all loads evenly on the platform. See the back cover for maximum platform load.
NEVER use damaged equipment. (Contact UpRight for instructions. See toll-free phone number on back cover.)
NEVER change operating or safety systems.
INSPECT the machine thoroughly for cracked welds, loose hardware, hydraulic leaks, damaged control cable,
loose wire connections and wheel bolts.
NEVER climb down elevating assembly with the platform elevated.
NEVER perform service on machine while platform is elevated without blocking elevating assembly.
NEVER recharge battery near sparks or open flame; batteries that are being charged emit highly explosive
hydrogen gas.
AFTER USE secure the work platform against unauthorized use by turning chassis key switch off and removing
key.
NEVER replace any component or part with anything other than original UpRight replacement parts without the
manufacturer's written consent.
All manuals and user guides at all-guides.com
all-guides.com