1 |
P a g e
Revised 10.3.2018sp
ACCESS CONTROL SOLUTIONS
Manual Keypad Lock Programming Guide
Covered lock models: E4TKSC, E5TKSB, E5TKSBS, E5TKSC, E5TKSCS
(E5RFKSC model lock programming is NOT covered by this guide)
Eternity 4 Eternity 5
General Information:
E5 v4.1 non-software lock:
The non-software version of the E5 lock is programmed completely using the
keypad on the E5 itself. A personal computer
cannot
be used for programming. If you
have purchased a non-software version of the E5 and later wish to upgrade to the
software version E5, your E5 (
except E5RFKSC
) can be retrofitted with a replacement
printed circuit board converting it to software operation. Field retrofit is possible but not
normally recommended. Contact your dealer or distributor for details.
E4 / E5 v8.6 software locks:
The software version of the E4 or E5 can be programmed either manually via the
keypad on the E4 / E5
or
with a personal computer, DS1977 program iButton key,
software and a Blue-dot USB reader. Most manual program modes and methods used by
the non-software E5 are available when manually programming the software version E4
or E5. However, an important consideration is that once you elect to program your E4 /
E5 software lock manually instead of using a personal computer you must continue to use
that same method.
You cannot mix the two programming methods for a given lock.
