BARCODE SCANNER
Programming the
LS1902-T
&
LS2208
for use with
StarShip
These instructions are for the Symbol LS1902-T & LS2208 Barcode scanner
ONLY!
The following instructions will allow the user to scan a bar-coded
Invoice\Order number into Starship and automatically “press” the Enter key.
Repetitive keystrokes such as SAVE, DEFER, REPEAT, and NEXT can
also be programmed. These repetitive keystrokes can be scanned using the
preprinted Barcodes at the end of these instructions.
You must tell the scanner what kind of keyboard connection you are using
by scanning the appropriate Barcode on the following page. Connect the
scanner to the PC and Keyboard while the PC is on (see page 1-6 of the
Online Manual for connection instructions). IMPORTANT: The keyboard
will be disabled until you scan one of the Barcodes on the next page.
The “ENTER” command must be programmed before any of the other
commands are entered. To program a command, “scan” each barcode in
order on that page. If you do not hear a beep or series of beeps, the scanner
did not read the barcode. Try scanning the barcode at different angles until
you hear the beep(s). If you make a mistake, scan the last barcode on that
page and start at the beginning of that page again. To reset the scanner back
to Factory Defaults scan this barcode:
