![background image](http://html.mh-extra.com/html/sealey/led026/led026_instruction-manual_1225390001.webp)
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL
Ensure the lamp is fully charged before initial use.
DO NOT
turn the lamp on when it is being charged.
DO NOT
shine directly into your, other person’s or
animal’s eyes.
DO NOT
allow children to use the lamp.
DO NOT
handle or move the lamp whilst it is being
charged.
DO NOT
use the lamp if you suspect that the battery or
the lamp casing is damaged.
DO NOT
leave battery in a discharged state, recharge
battery immediately. Before storage, fully recharge the
battery, subsequently recharge the battery at least once
every six months of non-use.
1.2. ELECTRICAL SAFETY FOR USE OF CHARGER.
USE ONLY THE SUPPLIED CHARGER PLUG FOR
CONNECTING LAMP TO THE POWER SUPPLY.
WARNING!
It is the user’s responsibility to read,
understand and comply with the following electrical
instructions:
You must ensure the risk of electric shock is minimised
by the installation of appropriate safety devices.
An RCCB (Residual Current Circuit Breaker) should be
incorporated in the main distribution board. We also
recommend that an RCD (Residual Current Device) is
used with all electrical products, particularly portable
equipment which is plugged into an electrical supply not
protected by an RCCB.
You must
also read and understand the following
instructions concerning electrical safety:
1.2.1.
The Electricity at Work Act 1989
requires all portable
electrical appliances, if used on business premises, to be
tested by a qualified electrician, using a Portable
Appliance Tester (PAT), at least once a year.
1.2.2.
The Health & Safety at Work Act 1974
makes owners
of electrical appliances responsible for the safe condition
of the appliance and the safety of the appliance operator.
If in any doubt about electrical safety, contact a
qualified electrician.
1.2.3.
You must ensure that you:
Inspect the charger plug, cable and connector for wear
and damage to ensure items are safe before connecting
to the mains power supply. If worn or damaged
DO NOT
use.
Important:
Check that the voltage marked on the
charger plug is the same as the lamp.
Uncoil the cable between charger and the lamp.
DO NOT
pull the charger plug from the mains socket by
the lead.
WARNING! DO NOT use any other type of charger with
this product, other than the supplied mains or car
charger. Failure to observe this warning could result in
injury and/or fire and will invalidate the warranty.
DO NOT
try to take the charger plug apart.
DO NOT
use the charger plug to charge or power any
other electrical item.
DO NOT
get the charger wet, or use in wet, damp
conditions (for indoor use only).
1.3. BATTERY SAFETY
WARNING! To reduce the risk of burns or fire:
DO NOT
attempt to open, disassemble, modify or
service the battery pack.
DO NOT
crush, puncture, short external contacts or
dispose of in fire or water.
DO NOT
expose to temperatures above 60°C (140°F).
Replace only with the battery pack designated for this
product.
Recycle or dispose of used battery as stipulated by local
regulation.
If the electrolyte in the cells gets on your skin, thoroughly
wash with soap and water. If it gets in your eyes, rinse
thoroughly with cool water and seek immediate medical
attention.
Soft touch composite casing with comfortable ergonomic hand grip features 12 super bright SMD LEDs producing up to 400
lumens output with 2 selectable modes of brightness. Complete with 360° swivel hook and rear magnet for hands free
applications. Charge indicator flashes green and red when fully charged. Supplied with mains charger, in-car charger and stand
for free standing use.
Battery: ................................................................ 3.7V/2200mAh
Charging Time: ..................................................................4.5hrs
Operating Time: .................................................................2/4hrs
Lumen Output .................................................................... 400lm
2. INTRODUCTION / SPECIFICATION
Original Language Version
LED026 Issue: 1 - 11/05/12
INSTRUCTION MANUAL FOR:
CORDLESS12 SMD LED
RECHARGEABLE INSPECTION
LAMP
LITHIUM-ION
MODEL No.
LED026
© Jack Sealey Limited