background image

I N S T R U C T I O N S   F O R :

CV JOINT BOOT CLAMP KIT

MODEL NO.   

BSL102

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions 

and properly maintained, give you years of trouble free performance.

BSL102  - 1 - 281004

1. SAFETY INSTRUCTIONS

IMPORTANT:

PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE OR

PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

2. SPECIFICATION & CONTENTS

SPECIFICATION. 

Banding is 430BA Stainless Steel, 5.5mm wide and 0.4mm thick.

Tensile strength of banding:  . . . . . . . . .480N/mm

2

Stainless Steel Band Cassette:  . . . . . .183ft. (56 mtr) 

Seals:  . . . . . . . . . . . . . . . . . . . .x150

Pliers:  . . . . . . . . . . . . . . . . . . . . . .x1

Dispenser:  . . . . . . . . . . . . . . . . . . . .x1

1.1

GENERAL SAFETY

3

Carefully read these operating and safety instructions before use. 

Keep them for future reference.

3

Keep the work area clean, uncluttered and ensure there is 

adequate lighting.

3

Maintain correct balance and footing. Ensure the floor is not 

slippery and wear non-slip shoes.

3

Remove ill fitting clothing. Remove ties, watches, rings, and other 

loose jewellery, and contain and/or tie back long hair.

3

Keep children and unauthorised persons away from the working 

area.

7

DO NOT

use the clamp tool for any purpose other than that for 

which it is designed.

7

DO NOT

operate the clamp tool when you are tired or under the 

influence of alcohol, drugs or intoxicating medication.

p

WARNING!

Ensure Health & Safety, local authority, and general 

workshop practice regulations are adhered to when using this 

equipment.

1.2

MECHANICAL SAFETY

3

Maintain the clamp tool in good condition. 

7

DO NOT

operate the clamp tool if any parts are damaged or 

missing as this may cause failure and/or personal injury.

1.3

OPERATIONAL SAFETY

3

When working with the clamp tool you are advised to use 

protective equipment including safety shoes, work gloves and 

safety goggles.  

3

Never insert fingers into the tool.

3. OPERATION

3.1.

The four positions of the pliers are as follows.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

01284 757500

01284 703534

[email protected]

Sole UK Distributor

Sealey Group,

Bury St. Edmunds, Suffolk.

www.sealey.co.uk

Web

email

Position 1

Position 2

Position 3

Position 4

Reviews: