• This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should
be scrapped.
Instruction leaflet
Sentinel Solar PIR Wall Light
www.saxbylighting.com
For your safety, always switch off the supply before cleaning.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Recycling advice
Safety information
Saxby Lighting Ltd. BH23 3PE
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could damage the finish.
Fitting/replacing bulbs
Iss.1 21062018
75271
PIR Adjustment
• The unit must be installed in a vertical position, and
fitted between 1.8m and 2.5m above the ground.
• The PIR sensor can be adjusted, allowing the
detection distance to be altered to suit the location.
The detection angle is set at 180 degrees. The
duration that the lamp stays on can be altered from
10±5 seconds to 60±10 seconds. The detection
distance "SENS" can be adjusted up to 10m Use a
small screwdriver to adjust the ‘TIME’ and ‘SENS’
screws. When adjusting the sensitivity (detection
distance) in daylight it will be necessary to cover the
sensor to simulate night time.
Detection range can be adjusted
by turning 'SENS' screw
Adjustable up to 10 metres
Duration the bulb stays on is
adjustable by turning 'TIME' screw
The sensor trigger point is adjust-
able by turning the ‘LUX’ screw.
Base of product
