Cree Edge
™
LED High-Output High Bay Luminaire
Transportation, Direct, Pendant, Hook and Cord Mounts
1 of 2
LPN00102X0001A2_A
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should
always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER
- Risk of shock- Disconnect power before installation.
DANGER
– Risque de choc – Couper l’alimentation avant
l’installation.
2. This luminaire must be installed in accordance with the NEC or
your local electrical code. If you are not familiar with these codes
and requirements, consult a qualified electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n’êtes pas familier avec ces codes et ces
exigences, veuillez contacter un électricien qualifié.
3. Ensure the mounting surface is capable of supporting the weight
of the luminaire after installation.
4. Due to the weight of the luminaire, 3 people may be necessary
during installation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
MOUNTING - TRANSPORTATION/
DIRECT MOUNT
STEP 1:
Remove the (4) nuts and washers securing the
retained Mounting Bracket Bolts to the top of
the mounting bracket. Remove the top piece
of the mounting bracket assembly from the
luminaire. See
Figure 1.
STEP 2:
Align the mounting bracket removed in Step
1 on an appropriate mounting surface. Using
customer supplied 3/8” minimum mounting
bolts, secure the bracket to the mounting
surface. See
Figure 2.
STEP 3:
Once the mounting bracket is secured to the
mounting surface,
re-secure the luminaire using the nuts and
washers removed in Step 1 to 180 in/lbs.
STEP 4:
Install a suitable Listed cord strain relief
brushing or bushing in the customer supplied
junction box, and feed the luminaire’s cord
through it.
STEP 5:
Connect the cord to the supply wiring per the
Electrical Connections
section.
MOUNTING - PENDANT MOUNT
STEP 1:
Remove the (4) nuts and washers securing the
retained Mounting Bracket Bolts to the top of
the mounting bracket. Remove the top piece
of the mounting bracket assembly from the
luminaire. See
Figure 1.
STEP 2:
Install the pendant fitter using (4) supplied
screws to the top of the mounting bracket. See
Figure 3.
STEP 3:
Secure the mounting bracket to the luminaire
using the nuts and washers removed in Step 1
to 180 in/lbs.
STEP 4:
The pendant can be adjusted laterally by the
pendant fitter to the desired position and then
tightening the (4) Adjustment Screws. See
Figure 3.
STEP 5:
Size the customer supplied pendant
accordingly and ensure that the pendant and
mounting surface is capable of supporting the
weight of the luminaire.
1
2
Mounting Bracket
Bolts (4)
Mounting Holes For Customer
Supplied 3/8” Mounting Bolts
Adjustment
Screws (4)
Pendant Fitter
3
NOTES:
• Pendant and hooks are only supplied with luminaire when ordered
as “Pendant” or “Hook and Cord” mounting.
• Prior to installation, store luminaire in a dry location protected from
rain, dust, and outdoor environment. If equipped with a photocell
receptacle, do not store or install luminaire outdoors without
immediately installing a suitable photocell, shorting cap, or other
compatible device. Do NOT leave receptacle open to environmental
elements. Luminaires with a top-mounted photocell receptacle
should not be installed in an up-light position or at a tilt greater
than 45 degrees from the down-light position.
