![background image](http://html.mh-extra.com/html/rab-design/ora-led/ora-led_instructions_775710001.webp)
INSTALLATION INSTRUCTIONS
RAB DESIGN LIGHTING INC.
22/10/2019
1
ORA-LED
ELECTRICAL SHOCK HAZARD
READ, UNDERSTAND
, and
FOLLOW
these instructions
before installing the equipment.
WARNING
SAFETY
Proper grounding is required to ensure personal safety.
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
Do not use this equipment for anything other than its intended purpose.
Servicing this equipment should be performed by qualified service personnel.
Save these instructions.
INSTALLATION
KNUCKLE MOUNT
Pull the wires from the junction box or cover (not provided).
Connect the wires as per wiring diagram.
Mount the fixture to the junction box or cover with ½” NPT conduits
Loosen the screws on the yoke to adjust a suitable orientation and then
tighten the screws.
YOKE MOUNT
DO NOT REMOVE THE YOKE FROM THE FIXTURE.
Mount the fixture on the desired location with appropriate screws. Drill
holes if necessary.
Pull the wires from the junction box and connect the wires as per wiring
diagram.
Loosen the screws on the yoke to adjust a suitable orientation and then
tighten the screws.
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.