POWERMADD
®
M 34269
651-462-8465
www.powermadd.com
Figure 1
Tri-Mount
Installation Instructions for Part No. 34269
HARDWARE INCLUDED:
SENTINEL HARDWARE
TOOLS REQUIRED:
Qty Description
Qty Description
-4mm hex wrench
2
Rod Mount
2
M6 x70mm bolts
-10mm wrench
2
Handle Bar Mount
4
13mm Spacers
-17mm wrench
2
Duckbill Spacer
6
10mm Nut
(SEE NOTE BELOW)
2
6mm Lock Nut
2
6mm Bolt
4
Washers
READ ALL INSTRUCTIONS CAREFULLY BEFORE
INSTALLATION!
NOTE:
PowerMadd’s Tri-mount is designed to mount to the upward
sweep section of your handle bars (see the Figure 1).
STEP 1
:
Thread the rod mount into the handle bar mount. Do not
tighten yet, you will need to adjust this later.
STEP 2:
Install the handle bar mount onto the upward sweep of
your bars (see Figure 1).
STEP 3:
Remove the 6mm lock nut and 6mm bolt from the
Duckbill spacer. The Duckbill spacer goes between the two mounting
tabs of your handguard. Mount the handguard as shown in Figure 2.
Slide the 6mm bolt through both the handguard tabs and Duckbill
spacer. Do not install lock nut yet. There are more adjustments to be made.
STEP 4:
Position the handle bar mount so that the spine of the
handguard is close to parallel with your hand grips and with enough
space to operate your levers. This can be accomplished by moving the
handle bar mount up and down on your handle bars and twisting on
your handle bars and by rotating the rod mount up and down. Once
you get the handguards where you want them, tighten the handle bar
mount with a 4mm hex wrench. Then tighten the 10mm nut on the rod
mount against the bar mount using a 17mm wrench so the rod is
locked into place.
STEP 5:
Position the handguard so that the end of the handguard is
even with the end of your handle bars. You can also adjust the tilt of
the handguard to your personal taste. This can be accomplished by
spinning the two 10mm nuts and Duckbill spacer in or out as needed.
(You will need to remove your handguard to do this) Once you have
your adjustments, tighten the two10mm jam nuts with 17mm
wrenches. Install the handguard as you did in step 3 but this time
install the 6mm lock nut and tighten with 10mm wrench. Repeat step
5 for both sides.
Note: All fasteners may need to be re-tightened after the first ride.
Check the tightness of the mount and handguard before each ride.
SENTINEL MOUNTING: When installing the Sentinel
Handguards with the Tri-mount, use the supplied bolts and
spacers shown in Figure 3.
Figure 2
Figure 3
