Technical Data Sheet & Installation Instructions
for 4041-5300 Temptrace™ Universal Kit for
Self-Regulating Bundles
Bulletin S/T-II
Contact Information:
Parker Hannifin Corporation
Parflex Division
1300 N. Freedom St.
Ravenna, OH 44266 USA
phone 330 296 2871
fax 330 296 0675
www.parker.com/pfd
Temptrace™
4041-5300 Electrical Splice or Tee Connection Kit for
SL & SH Series Self-Regulating Bundles
Scope
Kit can be used to make one input power connection or one input power splice connection or one splice/tee
connection as well as two end termination and RTV for bundle end seal.
An easily installed combination power splice and tee for Self-Regulating Bundle.
Bill of Materials
(1) 3/4" Pipe Stand
(1) 3/4" Pipe Nipple
(2) Sealing Grommet
(4) Stainless Steel Pipe Straps
(2-large, 2-small)
(1) 3 Hub Box
(1) Box Cover
(6) Wire Nuts
(2) Butt Splice Connectors
(1) SK-612 (Seal Patch Kit)
(3) Sleeve Rubber Heating Cable
Boot
(3) Ring Terminals
(2) Cable Entry Fittings
(1) 3/4" Pipe Plug
(1) Grounding Screw
(2) RTV-103BLK
(1) SS Label
(2) Reducing Bushings
(3) 1" Heat Shrink Tubes
(3) 3" Heat Shrink Tubes
(1) 4041-5300 Installation
instructions
(1) Fiberglass tape GT-3
Caution: The heater will come in contact with the power feed wires in the
junction box. Make sure that the temperature rating of the power feed wire
insulation is adequate for the heater used.
Ground Fault Equipment Protection Devices (GFEPDs):
The IEEE standard (515-2004) for heating cables requires the use of GFEPDs
with a nominal 30 milliampere trip level for “piping systems in classified areas,
those areas requiring a high degree of maintenance, or which may be exposed
to physical abuse or corrosive atmospheres.”
