Instruction Sheet
Circular Plastic Connector (CPC) Series 45
Unshielded Pass-Through Receptacle Kit
408-10091
LOC B
1 of 2
E2007 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
18 JUN 07 Rev B
1776186-1
Figure 1
Flange
Seal
Receptacle
Assembly
RJ45 In-Line
Coupler
Locking
Tab
Flange
Mounting Hole
(4 Places)
1. INTRODUCTION
CPC Series 45 Unshielded Pass–Through Receptacle
Kit 1776186–1 is designed for use in harsh
environments. The receptacle engages with CPC
shielded or unshielded plugs.
This receptacle kit is designed for front or rear
panel–mount applications.
Instruction sheet 408-8951 provides assembly
and engagement instructions for the plugs.
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 5, REVISION SUMMARY.
2. DESCRIPTION
This receptacle kit consists of the components shown
in Figure 1.
3. ASSEMBLY PROCEDURE
1. Align the locking tab of the coupler (mating face
first) with the wide slot at the back (large diameter
end) of the receptacle assembly. Depress the
locking tab, and insert the coupler into the
receptacle assembly until there is an audible
“click.” See Figure 2, Detail A.
2. Fit the flange seal over the mating face (small
diameter end) of the receptacle assembly (for back
panel mount) or the back of the receptacle
assembly (for front panel mount) until it is flat
against the flange. Make sure that the mounting
holes align. See Figure 2, Detail B.
Figure 2
Detail A
Detail B
Flange Seal Flat Against Flange
of Receptacle Assembly
(Shown Installed for Front Panel Mount)
RJ45 In-Line Coupler Seated in
Receptacle Assembly
Assembling Receptacle Kit
3. Cut the panel using the dimensions provided in
Figure 3.
Figure 3
Recommended Panel Cutout
Maximum Panel Thickness: 3.18 mm [.125 in.]
3.68+0.15 mm
[.145+.006 in.]
(4 Places)
37.84+0.15 mm
[1.49+.006 in.]
36.53+0.25 mm
[1.438+.010 in.]
Note: Not to Scale
36.53+0.25 mm
[1.438+.010 in.]
NOTE
i
NOTE
i
