Miller Edge AW12-RF Installation Instructions Download

Page: 1 / 4

AW12-RF/MRF-01 INSTALLATION INSTRUCTIONS

Preliminary

PARTS LIST

PART NUMBERS

-AW12-RF Single Channel

Transmitter/Air Wave™ Switch

Assembly

-MRF-01 Single Channel Receiver

-P/N=? Battery, CR2032

-(4) #6-20x3/4”, Screw, Self-Drilling

INSTALL TRANSMITTER/AIR

WAVE™SWITCH ASSY

-Open box, unpack battery and remove

lid from the AW12-RF.

-Install CR2032 battery as shown with

the “+” side up. Notice that the Red LED

blinks once upon insertion.

-Now position & attach, with provided

screws, your AW12-RF to your bottom

angle or end stile of your door. Replace

lid.

-Now, dependent upon your “kit”, make

the necessary airline connections.

Summary of Contents for AW12-RF

Page 1: ...Screw Self Drilling 2 INSTALL TRANSMITTER AIR WAVE SWITCH ASSY Open box unpack battery and remove lid from the AW12 RF Install CR2032 battery as shown with the side up Notice that the Red LED blinks...

Page 2: ...PROGRAMMING Apply power to the receiver Green Power LED stays on Channel 1 Red LED will be blinking To enter Learn mode simply press your fingertip onto CH1 in the LEARN BUTTON section of the PCB The...

Page 3: ...ciated Wink Off once per TX message received Blinks rapidly during Learn Mode Red per channel Relay State Learn Mode Off when Relay is Clear On when Relay is in Fault Blink very slowly for Low Battery...

Page 4: ...FERENCE RECEIVED INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FC...