C
SF
ELECTRONIC CYLINDER USER GUIDE
INSTALLATION USE AND MAINTENANCE INSTRUCTIONS FOR END USERS
KEY WARNING LIGHTS
Battery charge status warnings without introducing User or Programming key into cylinder:
To see battery charge status keep centre of key grip pressed on warning light side for around 3 seconds:
• 1 green flash: battery charged
• 1 yellow flash: battery almost flat
• 1 red flash: battery flat
User key warnings whilst introducing key into cylinder:
• 1 green flash: key enabled to open; battery charged
• 1 yellow flash: key enabled to open; battery almost flat
• 1 red flash: key enabled to open; battery flat
• 2 red flashes: key not enabled to open
Programming key warnings whilst introducing key into cylinder:
• 1 green flash: key has already carried out operation on cylinder; battery charged
• 1 yellow flash: key has already carried out operation on cylinder; battery almost flat
• 1 red flash: key has already carried out operation on cylinder; battery flat
• 2 red flashes: key not enabled to carry out operations on cylinder
• Short green flashes: data loading or unloading operation. This operation stops with a visual warning that lasts twice as
long as previous flashes and is coloured:
o Green, if data transmission is correct and battery charged;
o Yellow, if data transmission is correct and battery almost flat;
o Red, if data transmission is correct and battery is flat;
o Double red flash, if error has been noted during data transmission
Open cap turning in anti-clockwise
direction
Remove cap and lift gold tab
slightly. Turn key to remove
batteries
Insert new batteries, positioning
them one at a time under the gold
tab. Close cap turning in a clockwise
direction until locked
REPLACING BATTERIES IN KEY
ATTENTION!
BATTERIES MUST NOT BE REPLACED IN POTENTIALLY EXPLOSIVE ATMOSPHERE ROOMS
USE INSTRUCTIONS
Use only
LITHIUM SONY CR1620 3 Volt (70mAh)
batteries.
ATTENTION!
BEFORE INSERTING THE KEY INTO THE CYLINDER PLACE YOUR HAND ON THE WALL IN ORDER TO
ELIMINATE ANY ELECTROSTATIC CHARGE ACCUMULATED.
