Information Sheet
TROLL
®
Accessories
Using the RuggedCable
®
System
TwiST -LoCk CabLe ConneCTionS
1. Remove the protective caps from the instrument connector end and cable
connector end.
Instrument connector end
Cable connector end
TIP: Retain the dust caps to protect the pins and o-ring from damage when cable is
not attached.
2. Take a moment to look at the connectors. Each has a flat side.
Flat
Flat
Instrument
Cable
Note the pins on the body connector (one on each side) and the slots on the
cable connector (one on each side).
pin
slot
3. Slide back the sleeve on the cable connector.
4. Orient the “flats” so they will mate up, and insert the instrument connector
firmly
into the cable connector.
Instrument
Cable
5. Slide the sleeve on the cable toward the instrument body until the pin on the
body pops into the round hole in the slot on the cable connector.
Instrument
Cable
ALWAYS REMEMBER!
Before using your cables, make
•
sure that the connector end of your
instrument has a greased o-ring that
is in good condition (not cracked or
sheared).
Before using your cables, make
•
sure that each cable end contains
a gasket. This ensures a secure
connection with the instrument.
Cables can be sheared off by heavy
•
machinery or the careless use of
cutting tools. Pay attention!
