The Contractors Choice
thermOweld
®
+1 (918) 627-5210 • 1-800-558-1373 • WWW.THERMOWELD.COM
ELECTRICAL GROUNDING • CATHODIC PROTECTION • ELECTRIC UTILITY • RAIL
Tel. +1.800.558.1373
Tel. +1.918.627.5210
www.thermoweld.com
INSTRUCTIONS FOR THERMOWELD GROUNDING CONNECTIONS - CABLE TO GROUND ROD
CR-1
Place end of cable under
the center of the tap hole.
Cable must sit on top of
ground rod. Use locking
pliers or a clamp on the rod
below the mold to prevent
it from slipping when the
mold is fired.
CR-2
Place cable in the mold. Cable must
sit on top of ground rod. Use locking
pliers or a clamp on the rod below
the mold to prevent it from slipping
when the mold is fired.
CR-24
Place cables in mold. Bottom run cable
must sit on top of the ground rod. Use
a pair of locking pliers or a clamp below
mold on ground rod to support the mold
and prevent slipping.
CR-17
Place end of tap cable under center of
tap hole. Run cable must sit on top of
the ground rod. Use a pair of locking
pliers or a clamp below mold on ground
rod to support the mold and prevent
slipping.
CR-25
Place cables into mold and secure
mold to ground rod with backing plate
attachment. Support mold to keep
it from sliding down the ground rod
when welding with locking pliers or
clamp below mold.
CR-3
Place cable into mold and secure
mold to ground rod with backing plate
attachment. Support mold to keep
it from sliding down the ground rod
when welding with locking pliers or
clamp below mold.
ECN 2552 REV "F" 03/05/13 34-5381-04
