![background image](http://html2.mh-extra.com/html/ibm/deskstar-16gp/deskstar-16gp_quick-installation-manual_3576546001.webp)
Quick installation guide
Deskstar 16GP
AT/IDE
Models: DTTA-350320, 350430, 350640
DTTA-350840, 351010, 351290
DTTA-351680
IBM storage products
Page 1
IBM Hard Disk Drive Technical Support Center version 3.1
Handling precautions
1.
Do not cover the breather hole!
Covering the
breather hole may result in loss of data.
2.
Do not press on the drive!
Do not apply any force
to the drive during handling or installation.
3. Always handle the drive with care to prevent
damage from shock, vibration, or electrostatic dis-
charge (ESD).
4. Do not open the static-protective bag containing
the drive until required. Static electricity can damage
the drive.
5. Turn off and unplug your computer. Remove the
cover.
6. When installing the drive, touch a grounded,
unpainted metal surface with the static-protective
package containing the drive for at least two seconds.
(This drains static electricity from the package and
from your body.)
7. Handle the drive carefully by the edges. Do not
touch any exposed printed circuit board.
8. Save the drive packaging material including the
ESD bag in the event that the drive must be returned.
Place the drive in an anti-static bag before placing it in
the shipping container. The warranty will be void if
the drive is not returned in IBM approved packaging.
Quick installation procedure
Note: It is advisable to backup all data before pro-
ceeding with the installation.
If your system BIOS cannot handle large capacity
drives (due to inadequate address locations, most
systems are limited to accessing drives with a cap-
acity of 8.4GB or less), you may need to use a disk
overlay program such as Ontrack’s Disk Manager.
The following procedure uses the Ontrack Disk
Manager software. Information on obtaining a copy of
Ontrack’s Disk Manager can be found on the Web at
www.ibm.com/harddrive.
Setting the jumpers
1. Refer to your computer manual to determine if you
require the 15- or 16-head logical architecture.
2. In a one drive system, configure your new drive as
Master (Device 0)
3. In a two drive system, one drive must be desig-
nated as the Master, the other as the Slave (Device 1)
4. When installing the new drive as a Slave, check
the Master drive to determine if a jumper change is re-
quired to indicate that a Slave drive is present.
5. Consult your manual to see if your computer sup-
ports Cable Select before choosing this option.
16 head logical architecture
Jumper pins
Master A-B & G-H
Slave A-B & C-D
Cable Select A-B & E-F
Slave Present E-F & G-H
15 head logical architecture
Jumper pins
Master A-C & G-H
Slave A-C
Cable Select A-C & E-F
Slave Present A-C, E-F
& G-H
39 19 1 I G E C A
40 20 2 H F D B