St
ep
2
St
ep
3
St
ep
4
St
ep
5
St
ep
6
St
ep
7
St
ep
8
Install Generator
Warning Module Connections
Install Warning Module
Making the Connection to the Generator
Cab Silencer
Install the Generator on top
of the overhead guard and
at least 4” from the frame.
It
should be as far from the
strobe light as possible.
Use
the U-Bolts to secure the
Generator to the overhead
guard.
4
in
.
Connect Warning Module (Plug) to Generator (Receptacle).
(For weather shield mounts the connection is already made
inside the weather shield)
Connection to generator
should be pointed up
In order to avoid battery, drain while
the vehicle is off, connect Cab Silencer
to a switched and fused (5A min)
circuit.
Place the Cab Silencer within
≈30” of the Operator’s PAD
AND
4ft
away from the generator. The best
location is behind the operator's seat.
The Cab Silencer will blind the CAM if
installed on the overhead guard
.
www.hitnot.com
of the forklift (frame must be cleaned before
applying adhesive) where it can be seen and heard
by the operator.
An optional Auxiliary Light ( Light Only
Warning Module) can be connected to
the Generator to provide an additional
visual alert.
03/15/2022
DDAC20040rev3.8
All adjustments in Steps 7-9 need to be done by a professional.
U-Bolt Assembly
Silent Zone Adjust
•
Factory set to ≈30 in.
•
To decrease the size, unscrew the
cap from the Cab Silencer.
•
Activate a PAD and turn on truck.
•
Using a 3/32” slotted screwdriver,
turn the Pot until the PAD silences at
the desired location.
•
Replace cap.
St
ep
1
Average
Current:0.5A
Peak Surge
Current: 15A
Making the connection to machine power
Connect to a switched and fused (10A min) circuit.
The cable
exiting the
warning
module
with the
connector
goes to the
Generator
The cable
exiting the
warning
module
with the
bare wires
goes to the
machine for
power
Note: Zip Ties included for attaching the
cables to the frame of the machine.
Volume Adjust
using Range Adjust Tool
•
The clear plastic cover on the Warning Module can
be turned to reduce the sound.
•
Ensure all other MFGs and PADs within 90
ft are off. Remove the Clear Pull Tab and
Power on the range adjust tool within 4ft
of MFG. The warning module will sound.
Press the Red switch to increase the
volume of the warning module and the
Black switch to decrease the volume of
the warning module.
DO NOT APPLY VOLTAGE TO THE INCORRECT WIRES, IT MAY
RESULT IN HARDWARE DAMAGE.
(This step is for rear mounts for other mounting options
see page three)
Ensure the Silent Zone does not
extend outside of the vehicle
Place adhesive side of the
Warning Module to the frame
Use supplied Zip ties
to secure above and
below the warning
module.
DDAC MFG System Installation Guide
Model #; DDAC-PDS-SYS-2
Range Adjust Tool will NOT Work in the
Silent Zone.
