GENERAL INFORMATION
This wall remote control is designed to separately control your ceiling fan speed and light brightness.
The fan button will control the fan speed. (Hi, Medium, Low)
The light buttons will control the lights, brightness dimmer and off.
The red indicator on the transmitter will light when the button is pressed.
INSTALLATION AND OPERATING INSTRUCTIONS
1. HANDHELD TRANSMITTER
NOTE:
This remote control unit is equipped with 16 code combinations to prevent possible interference from or to other remote units. The
frequency switches on your receiver and transmitter have been preset at the factory. Please recheck to make sure the switches on transmitter
and receiver are set to the same position, any combination of settings will operate the fan as long as the transmitter and receiver are set to the
same position. (Fig. A)
Remove the set screw on the back of transmitter, take out the battery cover. Insert the 3 volt battery (included) and make sure they are seated
correctly in each recess with the Po sign facing up. When remove or insert the batteries, use a suitable screwdriver to loosen or tighten
the screws and open the back cover. (Fig. A)
NOTE:
To prevent damage to the transmitter, remove these batteries if not used for long periods
of time (months).
WARNING:
Chemical Burn Hazard. Keep batteries away from children.
This product contains a lithium button/coin cell battery. If a new or used lithium button/coin cell battery is swallowed or enters the body, it can
cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery
compartment does not close securely, stop using the product, remove the batteries, and keep it away from children. If you think batteries might
have been swallowed or placed inside any part of the body, seek immediate medical attention.
The batteries shall be disposed of properly, including keeping them away from children; Even used cells may cause injury.
2. INSTALLING RECEIVER IN THE CEILING FAN
A.
Safety precautions:
WARNING: HIGH VOLTAGE!
Household electrical power can cause serious injury or death. Disconnect the source of electrical power
to the ceiling fan by removing the fuse or switching off the circuit breaker.
B.
Installing receiver in fan.:
a. Remove the ceiling fan canopy from the mounting bracket.
b. Disconnect the existing wiring between the ceiling fan and supply at the electrical junction box.
c. Make the connections as follows, using the wire nuts supplied: (Fig. C)
CONNECT TO
Green fan wire...........................................Bare supply wire
Black receiver wire (AC IN L)..................Black supply wire
White receiver wire(AC IN N)..................White supply wire
White receiver wire (TO MOTOR N).......White fan wire
Black receiver wire (TO MOTOR L)........Black fan wire
Blue receiver wire(FOR LIGHT)..............Blue light wire
Fig. A
Fig. B
RECEIVER
Fig. C
AC SUPPLY
BLACK
WHITE
BARE
GREEN
WHITE
WHITE
BLUE
BLUE
BLACK
BLACK
RECEIVER
NOTE:
When installing the remote
control, be sure your fan control or
pull chain switch are in the "
HIGH
SPEED
" position and the light
control or switch is set to "
ON
".
3 SPEED FAN & LIGHT
REMOTE CONTROL WITH RECEIVER
INSTALLATION INSTRUCTIONS
Model: 980045
READ AND SAVE THESE INSTRUCTIONS
Set screw
Frequency switches
Transmitter
ON
ON
ON
Receiver
