1
Model TSC/TSR Pressure
Model COC Pressure
INSTALLATION/OPERATING INSTRUCTIONS
Two Stage Set Point Control
Ranges 0 - 30, 0 - 100, and 0 - 200 psi
Warning:
This Heat-Timer
control is strictly an operating control; it should never be used as a primary
limit or safety control. All equipment must have its own certified limit and safety controls required by local
codes. The installer must verify proper operation and correct any safety problems prior to the installation
of this Heat-Timer control.
LIMITED ONE YEAR WARRANTY
This Heat-Timer device was thoroughly tested for defects and workmanship before leaving our factory. We do warrant the equipment to
be free of defects under normal use for a period of one year from the date of installation. Transportation charges for factory repairs must
be prepaid. Damage to the Heat-Timer device or any of its components due to misuse, abuse, improper installation, or caused by power
failures, fire, flood, or lightning are not covered by this warranty. The company assumes no liability for indirect or consequential damages
of any nature. This Heat-Timer warranty applies only to the original purchaser/user, is not assignable or transferable, and does not cover
damage to the device occurring in shipment. Any service, repairs, modifications or alterations to the unit not expressly authorized by the
company will invalidate the warranty. This warranty is in lieu of all other warranties expressed or implied.
R
Blue
Blue
Black
Black
Red
Red
OUTPUT
UP
DOWN
PRESS TO READ
Output 1
Digital display reads
sensor value constantly
To power with
120VAC connect
to these wires
To power with 24VAC
connect to these two
terminals
Red light indicates
output status
Push these buttons to
adjust the settings
Push this button to display
the set points, differential
and offset
Output 2
SENSOR 24VAC
+
_
Black Red
Wire to 0-30, 0-100 or 0-200 psi pressure
transducer observing the polarity
= Set Point 1
= Set Point 2
= Differential
= Offset
= Shorted Sensor
= Open Sensor
