EZ Setup V3
EZ Hotspot Extender
EnGenius Europe | Veldzigt 28, 3454 PW Utrecht (NL)
0900-WIFIABC | www.wifiabc.com
Disclaimer: Information may be subject to changes without prior notification.
Remove the rear bottom panel.
Connect one end of the Ethernet cable (not supplied) to the LAN
(PoE) port on the EZ Hotspot Extender. The LAN (PoE) port can be
founded on the right-hand side as seen from the back of the device.
Connect the other end of the Ethernet cable to the PoE injector’s
PoE port. Connect the power adapter DC inlet to the 24V DC IN of
the PoE Injector and the power adapter to an electrical outlet. The
device is ready for configuring when the two LEDs (Power and
Wireless) are lit and the green LED stops blinking. This may take
about 30 seconds.
1
2
3
