03/19/2009
BI502
ELECTRO-BOILER
TS Series
INSTALLATION & OPERATING INSTRUCTIONS
Model EB-WO-13 EB-WO-23
EB-WO-18
EB-WO-27
APPLICATION:
This Electro-Boiler is factory equipped with
WarmFlo
smart controller.
WarmFlo
automatically regulates outlet water temperature based upon outside temperature and pre-
setup parameters (commonly called “outdoor reset”).
Primary application is any hydronic water heating system where reduced flow or
radiation can cause overheat conditions (example, zones).
However
, if it is a mixture of
large and small zones, the sudden capacity and flow changes may cause some internal
timing/overtemp conditions. With the mixture of zones the zone controller ZTS-* option
is highly
recommended
(see page 2).
This series is equipped for load management interrupt and can apply to standard
baseboard radiation, dual heat combinations, under floor radiant, wood boiler
supplement, etc.
Note:
If this installation does not include dual heat standby boiler, the front panel
switch must always be in the “normal” position.
ACCESSORIES:
Attached BL001 lists various accessory or option items which are not part of basic
Electro-Boiler. Also page 3 has additional information on slab stat. Page 2 gives
information on a zone control update which stages elements based upon zone capacity.
Note:
This product meets the requirements of the ASME Boiler and Pressure
Vessel Code.
Drawings:
BX501
BX502
BX201
BH502
BS502
BL001
XX017
