Thank you for purchasing your UV system, or your replacement quartz sleeve and lamp supplied by East
Midlands Water Company.
Please read through these instructions before carrying out your installation.
ULTRA VIOLET (UV)
WATER STERLISATION
INSTALLATION and REPLACEMENT
INSTRUCTIONS
Transformer with PVC cap
Rubber o-ring
(Please note this is packed in
a plastic bag and attached to the flex on the
transformer. This is to prevent the o-ring be-
ing lost in the packaging or being mislaid.
DO NOT DISCARD THESE O-RINGS.
They
are reusable and chargeable if you dispose
of them
This is the
stainless steel chamber
. You will need to
mount this appropriately to your particular application by
using the separate brackets (where supplied) or the ones
that are part of the unit. The chamber will need to be
plumbed into your water supply/connected to your
plumbing using the connectors shown (or similar).
Quartz sleeve and lamp.
HANDLE WITH CARE
. They are
MADE OF FRAGILE GLASS.
Avoid touching the centre
part of the sleeve/lamp. Pick up and handle by both ends.
The photograph shows the rubber o-ring in place on the
sleeve, approximately 2cm from the open end.
The lamp. This is filled with special incandescent
bearings which when heated, fluoresce and are a vital part
of the way the lamp operates. The bearings move around
inside the lamp and you may detect a slight ‘rattle’. This is
completely normal
Mounting brackets (may differ when
using UV with other water treatment
systems, such as RO’s)
Please check that you have all your components before commencing installation. Missing or
broken elements can only be replaced immediately on receipt of goods and upon proof of
damage. You should have the following elements;
Page 1
NEW INSTALLATION
ALL PAGES
REPLACING YOUR UV LAMP
PAGES 2,3 AND 4
REPLACING YOUR QUARTZ SLEEVE
PAGES 2 3 AND 4
UV 3.9 LPM SYSTEMS
PTFE tape
required
on these
joints
