![background image](http://html.mh-extra.com/html/dan-dryer/elite-classic-2000/elite-classic-2000_installation-and-users-instructions_504668001.webp)
INSTALLATION & USER INSTRUCTIONS
DAN DRYER
®
ELITE 2000 HAIR DRYER
Enclosed with the hair dryer are the installation instructions as well as a small
plastic bag containing:
2
pcs.
screws
2 pcs. rawlplugs
2
pcs.
washers
1
pcs.
plastic
cap
1 pcs. wall mounting bracket
PRIOR TO INSTALLATION:
Before installing the hair dryer, please check that the power supply has
sufficient capacity to handle the extra wattage specified on top of the dryer
housing.
Be sure to install the unit right next to a mirror, if any, thus preventing users
from stretching the flexible hose to the breaking point in the attempt to look at
themselves in the mirror.
The hair dryer is double-insulated and thus needs no earth connection.
FIXED WALL MOUNTING:
➊
Disassemble cover plate by removing the in Fig. 1 with
A
marked screw.
Attach unit to the wall, using the two holes marked with screws and
rawlplugs.
➋
Mark and drill two 6 mm holes in the wall, vertically underneath each other
and 198 mm apart (Fig. 2). Recommended installation height from the floor
to the top edge of the dryer is 180 cm.
➌
Feed supply cable through the cable inlet hole at the top right corner and
connect to terminal block. Attach dryer housing using the screws and
washers enclosed (Fig. 3).
IMPORTANT
Reassemble cover plate before test running the hair dryer.
Fixed installation must be carried out by a qualified electrician.
The ELITE hair dryer complies with the EU directive 87/308 on the reduction of
electromagnetic interference.