SPECIFICATIONS
-
12
watts, 24 volts
This Heated Bed is designed to provide gentle warmth for your pet.
IMPORTANT: In order to protect yourself and your pet, you must
read and follow all instructions.
ATTENTION
Do not expect the heater to feel warm if operated outside of the pet
bed. The heater must be insulated in order to become warm. Once
the heater is powered on and placed within the pet bed, the bed will
take approximately one to two hours to reach maximum temperature.
While powered on, it is normal for the transformer plug to feel warm.
CAUTION
1. Do not immerse heating pad in any liquid.
2. Do not use this product for any other purpose other than as a
warmer to be inserted between the inner pad lining and cover of a
dog and/or cat bed.
3. Do not leave heating pad outside or on top of pet bed.
4. For indoor use only. Not for use outdoors.
5. This pad is equipped with a wall mount transformer that operates at
24 volts. Never replace the power cord with any other cord.
6. The 24 volt transformer is a safety feature. Do not use an extension
cord. Any cord that is plugged into this transformer will carry a full
120 volts and will present a shock hazard should your pet chew on
the extension cord.
7. Do not puncture the heating pad.
8. Discard heating pad if unit becomes cracked or shows any other
signs or deterioration (chipping, cracking, or blistering).
9. Do not allow pets to chew the heating pad. Discard heating pad if
pet chews on it.
10. Remove heating pad before washing bed.
OPERATION
1. Unzip zipper and place heating pad in between the first two ¼” foam
layers. The bed is shipped with the heating pad in this position.
2. Note: there are 4 layers of foam (three ¼” layers on top and one ¾”
layer on bottom). You may regulate the amount of heat coming
through the bed by placing the warmer within the top three ¼”
layers. The deeper the heating pad is placed with these layers, the
lower the heat output coming through the bed. For maximum heat
output, place the heating pad under the first ¼” layer. For the least
amount of heat output, place the heating pad under the third ¼”
layer.
3. Place the heating pad in the center of the bed.
4. Place the bed on the floor so the ¾” layer is on the bottom.
5. Route the cord toward the end of the zipper path. Close the zipper
as far as possible. The cord should now exit from the corner.
WARRANTY
This product is warranted 12 months from the date of purchase. If you
believe this product is defective and still within the warranty period,
return it to the factory for inspection and possible replacement. The
warranty is voided if there is evidence of general abuse such as animals
chewing on the cord. This warranty does not cover incidental or con-
sequential damage resulting from either a defect in parts, materials, or
operation failure. Some states do not allow the exclusion or limitation
of the above damages so the above limitation may not apply to you.
No agent, employee, or representative of Miller Manufacturing has any
authority to bind Miller Manufacturing to any affirmation, represen-
tation or warranty directed towards any products bearing the Miller
Manufacturing name, except as stated herein. This warranty gives you
specific legal rights – you may also have other rights which vary from
state to state.
HEATED PET BEDS
Item # 12PB-S, 12PB-M, 12PB-L & 12PB-R
Read Instructions Thoroughly Before Use
Miller Manufacturing, Glencoe, MN 55336 USA • www.miller-mfg.com
303667
