ZyXEL Communications ZyWALL 10/10, User Manual

Page: 242 / 342

ZyWALL 10/10 II/50 Internet Security Gateway
21-16 Firmware and Configuration File Maintenance
21.4.10 Uploading a Configuration File Via Console Port
Step 1. Select 2 from Menu 24.7 – System Maintenance – Upload Firmware to display Menu 24.7.2
- System Maintenance - Upload System Configuration File . Follow the instructions as shown
in the next screen.
Figure 21-18 Menu 24.7.2 Using the Console Port
Step 2. After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on your
computer. Follow the procedure as shown previously for the HyperTerminal program. The
procedure for other serial communications programs should be similar.
Step 3. Enter “atgo” to restart the ZyWALL.
21.4.11 Example Xmodem Configuration Upload Using HyperTerminal
Click Transfer , then Send File to display the following screen.
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload System configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
router.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The router's console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed:(Y/N)